정옥찬 교수님

본문 바로가기
사이트 내 전체검색 검색어 필수


정옥찬 교수님

정옥찬 교수님

정옥찬 교수님

[ 생 체 시 스 템 공 학 ]


정옥찬 교수님

 

학력 전공

- 연구실 : 하연관(A) 414

- 전화 :(교내) 3785

- 이메일 :(memsoku@inje.ac.kr)

Post-Doctoral Fellow : April 2004 ~ Feb. 2007- Center for Promotion of the COE program, Ritsumeikan University, JAPANSenior Researcher : March 2002 ~ Feb. 2004- Research Institute of Science and Engineering at AJOU University, KOREAPh.D (2004) / M.S (1997) / B.S (1995)- Control and Instrumentation Engineering, AJOU University, KOREA (Supervisor : Prof. S. S. Yang)

 

Bio &Medical MEMS(Micro-Electro-Mechanical Systems)

- Micro Fluidic System- Micro Surgical Robot System- Multi-physics in Micro System

Biomedical Engineering - A System Approach to Bio Medicine- Bio Instrument &Bio System

 

경력

Best paper award in IEEE International Symposium on Micromechatronics and Human Science 2005 - Paper entitled "Pneumatic Micro finger as Endeffecter of Robot"

Paper award in The Japan Society of Computer Aided Surgery 2005- Paper entitled "Medical Application Oriented Flexible Micro Manipulator System by using MEMS    Technology"

 

Selected papers (2005-2007)

A. International Journals (IF)

-2007 (+3)-

- O. C. Jeong and S. Konishi, "Three-Dimensionally Combined Carbonized Polymer Sensor and Heater", Sensors and Actuators A. in press, 2007 (1.434)

- O. C. Jeong and S. Konishi, "Pneumatic Gas Regulator with Cascaded PDMS Seal Valves", Sensors and Actuators A. in press, 2007 (1.434)

- O. C. Jeong and S. Konishi, "Fabrication and Drive Test of All PDMS Pneumatic Micro Pump", Sensors and Actuators A. Vol. 3, Issue 2, pp. 849-856, 2007 (1.434)

-2006 (+1)-

- O. C. Jeong and S. Konishi, "All PDMS Pneumatic Micro Finger with Bidirectional Motion and Its Application", IEEE/ASME J. MEMS, Vol. 15, No. 4, pp. 896-903, Aug. 2006. (3.005)

-2005 (+5)-

- O. C. Jeong, S. W. Park, S. S. Yang, and J. H. Pak, "Fabrication of a Peristaltic PDMS micropump", Sensors and Actuators A, A 123-124 , pp. 453-458, Sept. 2005 (1.434)

- K. Naka, H. Nagae, M. Ichiyanagi, O. C. Jeong, and S. Konishi, "Investigation of Pyrolyzed Polyimide Thin Film as MEMS Material", Journal of Semiconductor Technology and Science, Vol.5, No.1, pp. 38-44, March 2005. (0)

- O. C. Jeong, S. W. Park, and S. S. Yang, "Fabrication and Drive Test of a Peristaltic Thermopnuematic PDMS Micropump", KSME International Journal, Vol. 19, No. 2, pp. 649-654, Feb. 2005. (0.344)

- O. C. Jeong and S. S. Yang, "Correlation between the Residual Stress and the Boron Concentration in Boron-doped Silicon Films", Japanese Journal of Applied Physics, Pt1, Vol. 44, No. 1A, pp. 350-357, Jan. 2005. (1.14

- K. H. Kim, H. J. Yoon, O. C. Jeong, and S. S. Yang, "Fabrication and Test of a Micro Electromagnetic Actuator", Sensors and Actuators A, Vol. 117, Issue 1, pp. 8-16, Jan. 2005. (1.434)

B. Peer Reviewed Conferences (Oral-O, Poster-P)

-2007 (+3)-

- O. C. Jeong and S. Konishi, "Peristaltic Micro Pump Acatued by Single Input Signal", uTAS, Pari, France, Oct. 2007. (P)

- O. C. Jeong and S. Konishi, "Self-generated Peristaltic Motion of Cascaded Diaphragm Actuators for Micro Fluidic systems", IEEE MEMS Conf., Kobe, Japan, pp. 135-138, Jan. 2007. (O)

- O. C. Jeong and S. Konishi, "3 Dimensionally Combined Pyrolyzed Polymer Sensor and Heater toward All Polymeric Gas Detection System", IEEE MEMS Conf., Kobe, Japan, pp. 111-114, Jan. 2007. (O)

-2006 (+6)-

- O. C. Jeong and S. Konishi, "Computational Modeling of Pneumatic Particle Capture Device", uTAS 2006, Tokyo, Japan, pp. 62-64, 2006. (P)

- S. Koninshi, O. C. Jeong, and S. Kusuda, "Pneumatic Micro Finger and Hand Toward Micro Surgical Tool", 2006 International Symposium on Flexible Automation, Japan, July 2006. (O)

- O. C. Jeong, T. Morimoto, and S. Konishi, "Pneumatically Driven All PDMS Gas Regulator", Asian Pacific Conference on Transducer 2006, C-4, Singapore, June 2006. (O)

- S. Konishi, M. Nokata, O. C. Jeong, S. Kusuda, T. Sakakibara, M. Kuwayama, and H. Tsutsumi, "Pneumatic Micro Hand and Miniaturized Parallel Link Robot for Micro Manipulation Robot System", IEEE ICRA, Orlando, FL, USA, pp. 1036-1041, May 2006. (O)

- O. C. Jeong and S. Konishi, "Pneumatic Particle Manipulator with Vibrator Matrix", IEEE MEMS Conf., Istanbul, Turkey, pp. 782-785, Jan. 2006. (P)

- O. C. Jeong, T. Morimoto, Y. Watanabe, and S. Konishi, "Peristaltic PDMS pump with perfect dynamic valves for Both Gas and liquid", IEEE MEMS Conf., Istanbul, Turkey, pp. 394-397, Jan. 2006. (P)

-2005 (+4)-

- O. C. Jeong, S. Kusuda, T. Sakakibara, S. Konishi, and M. Nokada, "Pneumatic Micro finger as Endeffecter of Robot", IEEE MHS, Nagoya, Japan, pp. 145-148, Nov. 2005. (O)

- O. C. Jeong and S. Konishi, "Fabrication of All PDMS micropump", IEEE MHS, Nagoya, Japan, pp. 139-143, Nov. 2005. (O)

- O. C. Jeong, T. Yamamoto, S. W. Lee, T. Fujii, and S. Konishi, "Surface modification, mechanical property, and multi-layer bonding of PDMS and its application", uTAS, Boston, USA, pp. 202-204, Oct. 2005. (P)

- O. C. Jeong, S. Kusuda, and S. Konishi, "All PDMS balloon actuators for bidirectional motion of micro finger", IEEE MEMS Conf., Miami, FL, USA, pp. 407-410, Jan. 2005. (P)

 

 

상단으로


TEL. 055-320-3291 FAX. 055-327-3292 [621-749] 경남 김해시 인제로 197

Copyright © 인제대학교 의용공학부 NETWORK TEAM All rights reserved.